LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Assembly
    GM1361712Courtesy of GENERAL MOTORS CORP.
  1. Slide the EVAP canister vent solenoid valve (4) over the bracket.

    Ensure the valve (4) is properly retained to the bracket.

  2. Connect the EVAP canister vent solenoid valve (4) to the EVAP canister (5). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Connect the electrical connector to the EVAP canister vent solenoid valve (4).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals