LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Fuel and Evaporative Emission Pipe Caution .
CAUTION: Refer to Gasoline/Gasoline Vapors Caution .
NOTE: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Notice .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of EVAP Assembly
    GM1361712Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector from the evaporative emission (EVAP) canister vent solenoid valve (4).
  3. Disengage the bracket retaining tab and remove the EVAP canister vent solenoid valve (4).
  4. Refer to Plastic Collar Quick Connect Fitting Service  in order to disconnect the following from the EVAP canister (5):
    • The EVAP vent hose (1)
    • The EVAP chassis hose/pipe (2)
    • The EVAP canister vent solenoid valve (4)
    5. Fig 2: View Of EVAP Canister
    GM1361733Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt (2) securing the EVAP canister (1) to the crossmember.
  6. Disengage the EVAP canister (1) from the crossmember bracket tabs (3).
  7. Remove the EVAP canister (1) from the vehicle.
scientia non olet · About LEMON Manuals