LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle only high enough to access the evaporative emission (EVAP) canister purge solenoid valve through the wheelhouse. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
    3. Fig 1: View Of EVAP Canister Purge Pipe, Throttle Body Module & EVAP Canister Purge Solenoid Valve
    GM1352026Courtesy of GENERAL MOTORS CORP.
  3. Refer to Plastic Collar Quick Connect Fitting Service  in order to disconnect the following from the EVAP canister purge solenoid valve (3):
    • The EVAP purge hose/pipe
    • The EVAP purge hose (1)
    4. Fig 2: View Of EVAP Canister Purge Solenoid Valve Engine Wiring Harness Connector
    GM1352021Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the EVAP canister purge solenoid valve.
    5. Fig 3: View Of EVAP Canister Purge Solenoid Valve
    GM1352022Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt securing EVAP canister purge solenoid valve to the engine.
  6. Remove the EVAP canister purge solenoid valve from the engine.
scientia non olet · About LEMON Manuals