LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new O-ring seals to the CKP sensor.
  2. Lightly lubricate the O-ring seals with clean engine oil.
    3. Fig 1: View Of Crankshaft Position Sensor
    GM858202Courtesy of GENERAL MOTORS CORP.
  3. Install the CKP sensor into the engine block.
  4. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the CKP sensor bolt threads.
    5. NOTE: Refer to Fastener Notice .
  5. Install the CKP sensor bolt.

    Tighten:  Tighten the CKP sensor bolt to 10 N.m (89 lb in).

    6. Fig 2: View Of Engine Wiring Harness
    GM1350744Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine wiring harness electrical connector (3) to the CKP sensor (1).
  7. Lower the vehicle.
  8. Perform the CKP System Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals