LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lightly lubricate the O-ring seal with clean engine oil.
    2. Fig 1: View Of Intake Camshaft Sensor
    GM858173Courtesy of GENERAL MOTORS CORP.
  2. Install the intake CMP sensor into the cylinder head.
  3. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the CMP sensor bolt threads.
    4. NOTE: Refer to Fastener Notice .
  4. Install the intake CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    5. Fig 2: View Of Intake CMP Sensor Engine Wiring Harness Connector
    GM1350719Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector to the intake CMP sensor.
scientia non olet · About LEMON Manuals