LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lightly lubricate the O-ring seal with clean engine oil.
    2. Fig 1: View Of Exhaust Camshaft Sensor
    GM858172Courtesy of GENERAL MOTORS CORP.
  2. Install the exhaust CMP sensor into the cylinder head.
    3. NOTE: Refer to Fastener Notice .
  3. Install the exhaust CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer
    GM1350714Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (4) to the exhaust CMP sensor (5).
scientia non olet · About LEMON Manuals