LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Control System & Fuel System - 3.7L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Actuator Solenoid Valve
    GM744600Courtesy of GENERAL MOTORS CORP.
  1. Install a new O-ring seal to the actuator solenoid valve (2).
  2. Lightly lubricate the O-ring seal with clean engine oil.
  3. Install the CMP actuator solenoid valve (2) into the cylinder head.
    4. NOTE: Refer to Fastener Notice .
  4. Install the camshaft position actuator solenoid valve bolt (3).

    Tighten:  Tighten the CMP actuator solenoid valve bolt to 10 N.m (89 lb in).

    5. Fig 2: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer
    GM1350714Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector (1) to the CMP actuator solenoid valve (6).
scientia non olet · About LEMON Manuals