LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Exterior Trim) >> Repair Instructions >> Rocker Panel Molding Replacement

Rocker Panel Molding Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Molding Replacement - Rocker Panel
GM1589401Courtesy of GENERAL MOTORS CORP.
Rocker Panel Molding Replacement

Callout Component Name
Preliminary Procedure: 
Open both doors on the side that the lower rocker panel molding is being removed.
1 Rocker Panel Lower Retainers (Qty: 6)
2 Rocker Panel Lower Retainers (Qty: 8)
Tip: 
  • Release the lower retainers by pulling downward at each location prior to releasing the upper retainers from the lower rocker.
  • Use the front fender clip to locate the rocker molding upon installation.
3 Rocker Panel
Tip:  Upon installation, ensure both doors are in the open position.
scientia non olet · About LEMON Manuals