Front Fender Emblem/Nameplate Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Emblem/Nameplate Replacement - Front Fender

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	Front Fender Nameplate Tip When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion. Use a J 25070 or equivalent to remove the old nameplate. Clean all the adhesive residue from the fender, wipe the surface dry with a clean lint-free towel prior to installing new GM nameplate. Press the nameplate firmly to the fender to ensure full adhesion to the fender.

Callout

Component Name

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Front Fender Nameplate

Tip

When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
Use a J 25070 or equivalent to remove the old nameplate. Clean all the adhesive residue from the fender, wipe the surface dry with a clean lint-free towel prior to installing new GM nameplate.
Press the nameplate firmly to the fender to ensure full adhesion to the fender.