LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Engine Mechanical - 4.6L - 4 Of 4) >> Off-Vehicle Repair Instructions (3 Of 3) >> Power Steering Pump Installation

Power Steering Pump Installation

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Power Steering Pump Retaining Bolt
    GM71094Courtesy of GENERAL MOTORS CORP.
  1. Place the power steering pump in position in the engine valley. Slide the molded wedge into the retaining feature cast into the cylinder block.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
    IMPORTANT: You MUST push the power steering pump toward the rear of the engine as much as possible before tightening the bolt.
  2. Install the power steering pump bolt.

    Tighten:  Tighten the power steering pump bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals