Oil Pump Installation

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 45059 Angle Meter. See Special Tools .

Fig 1: Identifying Oil Pump Assembly Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the oil pump drive spacer into the oil pump so that the drive flat engages the pump rotor.
Position the oil pump on the crankshaft.
Install the retaining bolts.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Apply upward pressure on the pump while tightening the three retaining bolts. Tighten the bolts in the sequence (1, 2, 3) shown.
1. First Pass
  Tighten: Tighten the oil pump mounting bolts in sequence to 10 N.m (89 lb in).
2. Final Pass
  Tighten: Tighten the oil pump mounting bolts in sequence an additional 35 degrees using the J 45059 . See Special Tools .