LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Engine Mechanical - 4.6L - 4 Of 4) >> Off-Vehicle Repair Instructions (3 Of 3) >> Drive Belt Installation

Drive Belt Installation

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Power Steering Pulleys, Drive Belt & Drive Belt Tensioner
    GM52981Courtesy of GENERAL MOTORS CORP.
  1. Route the accessory drive belt around the crankshaft (5), the air conditioning compressor (4), the idler (3), the generator (2), and the drive belt tensioner (6) pulleys.
  2. Insert a 1/2 inch drive ratchet into the drive belt tensioner (6).
  3. Rotate the tensioner clockwise.
  4. Route the remainder of the belt around the power steering pulley (1).
  5. Slowly rotate the drive belt tensioner counter clockwise until the drive belt is tight.
  6. Remove the 1/2 inch drive ratchet.
  7. Check the drive belt for proper seating in all pulleys.
scientia non olet · About LEMON Manuals