LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Replacement (FE1, FE3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Wheel Drive Shaft From/To Transaxle
GM189013Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel drive shaft (2) to the transaxle (1).
  2. Verify that the wheel drive shaft is properly engaged to the transaxle by grasping the inner tripot housing and pulling outward. Do not pull on the wheel drive shaft bar.

    The wheel drive shaft will remain firmly in place when properly engaged.

    Fig 2: Installing Wheel Drive Shaft To Hub & Bearing Assembly
    GM442471Courtesy of GENERAL MOTORS CORP.
  3. Install the wheel drive shaft to the hub and bearing (2).
  4. Connect the ball joint to the steering knuckle. Refer to Lower Ball Joint Replacement (FE1, FE3) .
  5. Connect the wheel speed sensor electrical connector.
  6. Install the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement (FE1, FE3) .
    Fig 3: Preventing Rotor Turning Using Drift Or Punch
    GM141983Courtesy of GENERAL MOTORS CORP.
  7. Insert a drift or punch (1) into the rotor and against the caliper in order to prevent the hub and bearing from turning.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  8. Install the new wheel drive shaft spindle nut (2) to the wheel drive shaft.

    Tighten:  Tighten the wheel drive shaft spindle nut to 160 N.m (118 lb ft).

  9. Connect the outer tie rod end to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  10. If equipped with road sensing suspension, connect the level sensor link to the ball stud on the lower control arm. Refer to Front Position Sensor Replacement - Electronic Suspension .
  11. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals