Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- The ECM turns OFF the MIL after the third consecutive trip in which the TCM does not send a MIL illumination request.
- The TCM clears the DIC message when the condition no longer exists.
- A scan tool can clear the DTC.
- The TCM clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without an emission-related diagnostic fault occurring.
- The TCM cancels the DTC default actions when the ignition switch is OFF long enough in order to power down the TCM.
DTC P2534
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
IMPORTANT:
Before clearing the DTCs, use the scan tool in order to record the Freeze Frame and Failure Records for reference. Using the Clear Info function will erase the stored Freeze Frame and Failure Records from the TCM.
|
- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
| 3 |
|
- | Go to Step 4 | Go to Step 5 |
| 4 | Test the ignition 1 voltage circuit of the TCM for a short to ground between the underhood fuse block and the TCM. Refer to Testing for Short to Ground and Wiring Repairs . Did you find and correct the condition? |
- | Go to Step 7 | - |
| 5 | Test the ignition 1 voltage circuit of the TCM for an open between the underhood fuse block and the TCM. Refer to Testing for Continuity and Wiring Repairs . Did you find and correct the condition? |
- | Go to Step 7 | Go to Step 6 |
| 6 | Replace the TCM. Refer to Control Module References . Did you complete the replacement? |
- | Go to Step 7 | - |
| 7 | Perform the following procedure in order to verify the repair:
Has the test run and passed? |
- | Go to Step 8 | Go to Step 2 |
| 8 | With a scan tool, observe the stored information, capture info and DTC info. Does the scan tool display any DTCs that you have not diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle | System OK |