LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Engine Cooling System) >> Repair Instructions >> Drive Belt Tensioner Replacement - Water Pump >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump Drive Belt Tensioner
    GM1662860Courtesy of GENERAL MOTORS CORP.
  1. Position the water pump drive belt tensioner to the water pump housing.
    2. NOTE: Refer to Fastener Notice .
  2. Install the water pump drive belt tensioner studs.

    Tighten:  Tighten the studs to 10 N.m (89 lb in).

  3. Install the water pump drive belt. Refer to Water Pump Belt Replacement .
scientia non olet · About LEMON Manuals