LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Engine Control System & Fuel System - 4.6L - DTC P0351 To P2440) >> DTC P0685 or P0690 >> Repair Procedures

Repair Procedures

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Perform the Diagnostic Repair Verification after completing the repair.

  1. Refer to Control Module References for ECM replacement, setup, and programming.
  2. Clear the DTCs with a scan tool.
  3. Turn OFF the ignition for 30 seconds.
  4. Start the engine. If engine does not run, refer to Engine Cranks but Does Not Run .
  5. If other DTCs are set, refer to Diagnostic System Check - Vehicle .