LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Engine Control System & Fuel System - 4.6L - DTC P0351 To P2440) >> DTC P0403, P0404, P0405, P0406, or P042E >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If DTC P0641 or P0652 are also set, diagnose those DTCs first.
  1. With the ignition ON and the engine OFF, command the EGR from 0-90 percent. The EGR Position Sensor parameter should remain within 3 percent of the Desired EGR Position parameter through the entire range.
  2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records List.
  3. Engine running, observe the DTC information with a scan tool. DTCs P0403, P0404, P0405, P0406 or P042E should not set.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.