LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Tire Pressure Monitoring System) >> Description and Operation >> Tire Pressure Monitor Description and Operation (UH3) >> Tire Pressure Monitor Reset Procedure

Tire Pressure Monitor Reset Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

If tire pressure is adjusted or one or more tires is repaired, replaced, or rotated, the tire pressure monitoring system must be reset.

To reset the tire pressure monitoring system:

  1. Turn the ignition switch to RUN, with the engine off.
  2. Press the vehicle information button on the DIC until the PRESS Set/Reset TO RESET TIRE SYSTEM message appears on the display.
  3. Press and hold the DIC Set/Reset button for five seconds. After five seconds, the display will show TIRE PRESSURE SYSTEM RESET.

The system completes the calibration process during driving. The system learns the pressure at each tire throughout the operating speed range of your vehicle. The system normally takes between 20 and 45 minutes of driving in each of the following speed ranges to learn tire pressures: 40 to 64 km/h (25 to 40 mph), 64 to 96 km/h (40 to 60 mph), and 96 to 136 km/h (60 to 85 mph). This time may be longer depending on individual driving habits. Learning need not be accumulated during a single trip. Once learned, the system will remember the tire pressures until the system is reset.

scientia non olet · About LEMON Manuals