LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Suspension Control System - Suspension Damping) >> Repair Instructions >> Rear Position Sensor Replacement - Electronic Suspension >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Height Sensor Connector and Sensor Link From Ball Stud
GM517954Courtesy of GENERAL MOTORS CORP.
  1. Insert head of the sensor mounting stud into the key hole.
  2. Slide the sensor upward until the anti-rotation tab engages in the lower hole.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Tighten the sensor mounting nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  4. Connect the sensor link on the ball stud.
  5. Connect the height sensor connector.
  6. Install the wheel on the vehicle. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals