LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Suspension Control System - Suspension Damping) >> Diagnostic Information and Procedures >> DTC C0696 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Dynamic Test

  1. Install a 3A fused jumper wire between the 5-volt reference terminal and 5 volts. Install a jumper wire between the low reference terminal and ground.
  2. Sweep the suspension position sensor through the entire range while monitoring the voltage between the signal terminal and the low reference terminal. The range should vary between 0.35-4.75 volts without any spikes or dropouts.
    • If not within the specified range or is erratic, replace the applicable suspension position sensor.
scientia non olet · About LEMON Manuals