LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Cruise Control System) >> Diagnostic Information and Procedures >> Scan Tool Data List

Scan Tool Data List

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

The scan tool data lists contain all of the cruise control related parameters that are available on the scan tool for the Cruise Control System. The parameters in the list are arranged in alphabetical order. The data list column indicates the location of the parameter within the scan tool menu selections.

Use the scan tool data lists as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with Diagnostic System Check - Vehicle .

Use the scan tool data lists only after the following is determined:

The typical data values are obtained from a properly operating vehicle under the conditions specified in the first row of the scan tool data list table. Comparison of the parameter values from the suspect vehicle with the typical data values may reveal the source of the customer concern.

Cruise Control Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: The ignition is ON/The engine is OFF/Vehicle is in Park or Neutral/Cruise On/Off Switch is Turned OFF
ACC Gap Switch BCM Inactive/Increase/Decrease/Error Inactive
Clean Radar Indicator Message DSCC Data On/Off Off
Cruise Cancel Switch ECM Active/Inactive/Invalid Off
Cruise Control Active ECM Yes/No No
Cruise Control Switch BCM On/Off/Cancel/Set/Resume/Error Off
Cruise Disengage 1-8 History Cruise Disengagement/ECM Last 8 reasons for cruise control disengagement Varies
Cruise On/Off Switch ECM Active/Inactive Active
Cruise On/Off Switch Status DSCC Data Active/Inactive Active
Cruise Resume/Accel. Switch ECM Active/Inactive/Invalid Off
Cruise Set/Coast Switch ECM Active/Inactive/Invalid Off
Driver Selected Speed DSCC Data km/h (mph) 0 km/h (0 mph)
Driver Throttle Override Status DSCC Data Active/Inactive Inactive
Engine Speed ECM RPM Varies
Follow Speed DSCC Data km/h (mph) 0 km/h (0 mph)
HUD Virtual Device DSCC Data Present/Not Present Present
Ignition 1 Signal ECM Volts Varies
Service Radar Indicator Message DSCC Data On/Off Off
Target Found this Ignition DSCC Data Yes/No No
Vehicle Ahead Indicator Message DSCC Data On/Off Off
Vehicle Speed Sensor ECM km/h (mph) 0 km/h (0 mph)