LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Suspension Control System - Suspension Leveling (ASCM)) >> Repair Instructions >> Air Suspension Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Control Module & Electrical Connector
    GM1671455Courtesy of GENERAL MOTORS CORP.
  1. Install the control module (2) to the bracket. Ensure the upper and lower locking tabs are engaged.
  2. Connect the electrical connector (1).
  3. Install the compressor assembly to the vehicle. Refer to Compressor Assembly Automatic Level Control Air Replacement .
  4. Perform the suspension position calibration procedure. Refer to Control Module References for replacement and setup information.
scientia non olet · About LEMON Manuals