LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice .
    Fig 1: Identifying Sensor & Retaining Bolt
    GM11835Courtesy of GENERAL MOTORS CORP.
  1. Install the vehicle speed sensor (130) and the retaining bolt (131). Install a new O-ring seal on sensor if necessary.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  2. Install the electrical connector at the sensor.
    3. Fig 2: Mounting Bolt Locations For Front Transaxle Brace
    GM588753Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts (1, 3) securing the front transaxle brace (2) to the transaxle and right cylinder head.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals