LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM521323Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the engine assembly with a suitable jack.
  3. Remove the nuts (1) securing the transmission mount (2) to the transmission mount bracket (3).
    4. Fig 2: Identifying Mount to Frame Bolts & Nuts
    GM521324Courtesy of GENERAL MOTORS CORP.
  4. Raise the jack allowing the engine assembly to lift from the engine frame slightly.
  5. Remove the bolts (3) securing the mount to the frame.
  6. Remove the one nut (2) securing the mount to the frame.
  7. Remove the mount (1).
scientia non olet · About LEMON Manuals