LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Rear Mount Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM521323Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the engine assembly with a suitable jack.
  3. Remove the nuts (1) securing the transmission mount (2) to the transmission mount bracket (3).
    4. Fig 2: Identifying Transmission Mount Bracket Mounting Bolts
    GM793606Courtesy of GENERAL MOTORS CORP.
  4. Raise the jack allowing the engine assembly to lift from the engine frame slightly.
  5. Remove the transmission mount bracket mounting bolts.
  6. Remove the transmission mount bracket
scientia non olet · About LEMON Manuals