LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Rear Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transmission Mount Bracket Mounting Bolts
    GM793606Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the transmission mount bracket and mounting bolts to the engine.

    Tighten:  Tighten the bolts to 110 N.m (89 lb ft).

  2. Lower the transmission in position.
    3. Fig 2: View Of Engine Mount
    GM521323Courtesy of GENERAL MOTORS CORP.
  3. Install the nuts (1) to the mount (2) and mount bracket (3).

    Tighten:  Tighten the mount nut to 75 N.m (55 lb ft).

  4. Remove the engine assembly support jack.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals