LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Incase of power loss the brake transmission shift interlock (BTSI) switch must be manually released in order to remove the console trim plate. If no power loss proceed to step 4.
  1. Lift up the console trip plate. Refer to Front Floor Console Trim Plate Replacement .
    2. IMPORTANT: Wear gloves to protect hands from sharp edges.
    Fig 1: Identifying BTSI Pin Cover
    GM1709099Courtesy of GENERAL MOTORS CORP.
  2. Remove the BTSI pin cover (1).
    3. Fig 2: Identifying BTSI Pin
    GM1709101Courtesy of GENERAL MOTORS CORP.
  3. Depress BTSI switch pin (1) to release the shifter out of park.
  4. Remove the console trim plate (1). Refer to Front Floor Console Trim Plate Replacement .
    5. Fig 3: View Of Transaxle Range Selector Cable
    GM1964445Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission range selector cable terminal (2) from the shift control pin.
  6. Remove the transmission range selector cable (1) from the shift control base.
  7. Disconnect the electrical wire harness connector from the shift control.
  8. Remove the shifter assembly.
    Fig 4: View of Shifter Assembly
    GM291888Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals