LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transaxle Brace Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine to transaxle brace.
    2. Fig 1: View of Brace & Fasteners
    GM627408Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the fasteners into the engine and transmission.

    Tighten:  Tighten the brace bolts to 50 N.m (37 lb ft).

    3. Fig 2: View of Heat Shield
    GM627402Courtesy of GENERAL MOTORS CORP.
  3. Install the heat shield.
  4. Install the heat shield fasteners.

    Tighten:  Tighten the heat shield nuts to 50 N.m (37 lb ft).

  5. Install the right front tire. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals