LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Output Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the differential carrier. Refer to Differential Carrier Replacement .
  3. Remove the left drive axle. Refer to Wheel Drive Shaft Replacement (FE1, FE3) or Wheel Drive Shaft Replacement (FE7) .
    4. Fig 1: Identifying Output Shaft Snap Ring, Differential Side Gear, & Thrust Washer
    GM11843Courtesy of GENERAL MOTORS CORP.
  4. Push on the output shaft in order to expose the snap ring. Remove the output shaft snap ring (56).
  5. Remove the left side differential gear (118). Remove the thrust washer (117).
    6. Fig 2: View of Output Shaft
    GM687600Courtesy of GENERAL MOTORS CORP.
  6. Remove the output shaft (57) through the opposite end of the case.
scientia non olet · About LEMON Manuals