LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Case Extension Axle Seal Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right drive axle. Refer to Wheel Drive Shaft Replacement (FE1, FE3) or Wheel Drive Shaft Replacement (FE7) .
    2. Fig 1: Identifying Drive Axle Seal
    GM683801Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be careful not to damage the transmission case extension when removing the seal with a screwdriver.
  2. Remove the drive axle seal (1) in the following order:
    1. Use a screwdriver to pry out the seal from the transmission.
    2. Use pliers in order to remove the remaining housing of drive axle seal from the transmission.
  3. Inspect the drive axle seal mating surface on the drive axle housing for corrosion, grooves or nicks.
  4. Clean the drive axle seal mating surface on the drive axle housing with crocus cloth.
scientia non olet · About LEMON Manuals