LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Case Cover Axle Seal Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left drive axle. Refer to Wheel Drive Shaft Replacement (FE1, FE3) or Wheel Drive Shaft Replacement (FE7) .
    2. IMPORTANT: Be careful not to damage the transmission case cover when removing the seal.
    Fig 1: View of Drive Axle Seal
    GM683842Courtesy of GENERAL MOTORS CORP.
  2. Remove the drive axle seal (1). Pry out the seal from the transmission.
  3. Inspect the drive axle seal mating surface on the drive axle housing for corrosion, grooves or nicks.
  4. Clean the drive axle seal mating surface on the drive axle housing with crocus cloth.
scientia non olet · About LEMON Manuals