LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Cable Replacement - Console >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the park brake and chock the wheels.
    2. Fig 1: Identifying Manual Shift Lever & Shift Cable
    GM1964446Courtesy of GENERAL MOTORS CORP.
  2. Remove the range selector cable retainer (1).
  3. Disconnect the transmission range selector cable terminal (1) from the transmission manual shift lever pin.
    Fig 2: View of transmission range selector cable terminal
    GM1964447Courtesy of GENERAL MOTORS CORP.
  4. Press the locking tabs inward in order to release the transmission range selector cable (2) from the bracket.
  5. Remove the left console trim plate. Refer to Front Floor Console Side Trim Panel Replacement - Left Side .
  6. Remove the transmission range selector cable terminal (2) from the shift control pin.
    Fig 3: View Of Transaxle Range Selector Cable
    GM1964445Courtesy of GENERAL MOTORS CORP.
  7. Remove the transmission range selector cable (1) from the shift control base.
  8. Unplug the shift cable grommet at the cowl panel and remove the shift cable from the vehicle.
    Fig 4: View Of Shift Cable & Grommet
    GM294270Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals