LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Vehicle Speed Sensor and Transmission Fluid Cooler Pipe Fitting Removal

Vehicle Speed Sensor and Transmission Fluid Cooler Pipe Fitting Removal

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Sensor & Retaining Bolt
    GM11835Courtesy of GENERAL MOTORS CORP.
  1. Remove the 10 mm bolt (131) from the output shaft speed sensor.
  2. Remove the output shaft speed sensor and seal (130).
    3. Fig 2: Cooler Line Fitting & Seal
    GM1592014Courtesy of GENERAL MOTORS CORP.
  3. Remove the 19 mm cooler line fitting (3) and seal (4).
scientia non olet · About LEMON Manuals