LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Torque Converter and Oil Pump Drive Shaft Install

Torque Converter and Oil Pump Drive Shaft Install

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Inspection Points On Torque Converter
    GM15532Courtesy of GENERAL MOTORS CORP.
  1. Inspect the torque converter (1) lugs for damage and inspect the oil pump driven shaft for damage. Replace the turbine shaft seal (412).
    2. Fig 2: Oil Pump Driven Shaft & Torque Converter
    GM11831Courtesy of GENERAL MOTORS CORP.
  2. Install the following parts:
    • The oil pump driven shaft (2) into the turbine shaft
    • The new turbine shaft O-ring seal (412)
    • The torque converter (1)
  3. Remove the transmission from the base and then remove the holding fixture from the transmission.
scientia non olet · About LEMON Manuals