LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Scavenge Pipe Installation

Scavenge Pipe Installation

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Scavenge Tube
    GM15512Courtesy of GENERAL MOTORS CORP.
  1. Inspect the scavenge tube (54) for damage and clogging.
    2. Fig 2: Identifying Scavenge Tube & Seals
    GM11840Courtesy of GENERAL MOTORS CORP.
  2. Install the scavenge tube seal (53) into the case.
  3. Install the scavenge tube (54) into the scavenge tube seals (53) located in the case and in the driven sprocket support. Tap the scavenge tube (54) lightly with a plastic hammer to ensure a tight fit in both seals.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the scavenge tube bolt (15).

    Tighten:  Tighten the bolt to 8-14 N.m (6-10 lb ft).

scientia non olet · About LEMON Manuals