LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Parking Pawl and Pivot Pin Install

Parking Pawl and Pivot Pin Install

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Parking Pawl Pivot Pin
    GM11929Courtesy of GENERAL MOTORS CORP.
  1. Place the parking pawl (22) into the case slot.
  2. Install the parking pawl pivot pin (23) into the case.
  3. Install the parking pawl spring over the parking pawl. The hook end of the spring locates on the case, and the square end goes on top of the parking pawl.
    4. Fig 2: Checking Parking Pawl
    GM11930Courtesy of GENERAL MOTORS CORP.
  4. Tap the parking pawl pivot pin (23) in place while pressing down on the pawl and spring assembly (25).
  5. Verify the correct function of the parking pawl by moving the manual shaft and detent lever through the different ranges. Then return the manual shaft to the Park position.
scientia non olet · About LEMON Manuals