LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Output Shaft Removal

Output Shaft Removal

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Output Shaft Snap Ring, Differential Side Gear, & Thrust Washer
    GM11843Courtesy of GENERAL MOTORS CORP.
  1. Rotate the transmission so that the bottom pan (59) faces down.
  2. Push on the output shaft in order to expose the snap ring. Remove the output shaft snap ring (56).
  3. Remove the left side differential gear (118). Remove the thrust washer (117).
    4. Fig 2: Removing Output Shaft
    GM509537Courtesy of GENERAL MOTORS CORP.
  4. Remove the output shaft (57) through the opposite end of the case.
scientia non olet · About LEMON Manuals