LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> OSS Sensor and Cooler Fitting Installation

OSS Sensor and Cooler Fitting Installation

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Output Speed Sensor (OSS)
    GM1592067Courtesy of GENERAL MOTORS CORP.
  1. Inspect the output speed sensor (130) for damage or a cut seal (4).
  2. Inspect the cooler connector (3) for damaged threads, clogging, or a cut seal (4).
    3. Fig 2: Output Speed Sensor & Seal
    GM1592076Courtesy of GENERAL MOTORS CORP.
  3. Install the output speed sensor (130) and the seal (4).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the output speed sensor bolt (131).

    Tighten:  Tighten the bolt to 8-14 N.m (6-10 lb ft).

  5. Install the cooler fitting (3) and the new seal (4) or fitting (38) and seal (39) into the case.

    Tighten:  Tighten the cooler fitting to 25-29 N.m (19-21 lb ft).

scientia non olet · About LEMON Manuals