LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Low/Reverse Band and Fretting Ring Installation

Low/Reverse Band and Fretting Ring Installation

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Low Reverse Band
    GM11923Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: It may be easier to install the low reverse band if it is installed on the anchor pin first.
  1. Install the low reverse band (13) into the case. Be sure to properly anchor the band in the case with the servo pin stop at the case bore.
    2. Fig 2: View Of Fretting Ring
    GM11924Courtesy of GENERAL MOTORS CORP.
  2. Install the fretting ring (835) into the case. Keep the gap in the fretting ring toward the bottom pan with the recessed area next to the anchor pin.
scientia non olet · About LEMON Manuals