LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Input Speed Sensor and Wiring Harness Removal

Input Speed Sensor and Wiring Harness Removal

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Automatic Transmission Wiring Harness Assembly Retaining Bolts
    GM1217556Courtesy of GENERAL MOTORS CORP.
  1. Remove the two 8 mm bolts (15) from the automatic transmission input (shaft) speed (A/T ISS) sensor and the retainer.
  2. Disconnect the A/T ISS (14) and the harness.
  3. Remove the pass through connector and the automatic transmission wiring harness assembly (12) and O-ring (68) from the case. Remove by pushing the three tabs inward from the outside of the case.
scientia non olet · About LEMON Manuals