LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Fourth Band Installation >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

J 34741-3  Input Shaft Seal Sizer. See Special Tools .

    Fig 1: Identifying Fourth Band
    GM11947Courtesy of GENERAL MOTORS CORP.
  1. Install the fourth band (523) into the case. Seat the band properly onto the anchor pin with the seat of the servo pin toward the servo bore in the case.
    2. Fig 2: Installing J 34741-3 Over The Input Shaft Oil Seal Rings
    GM15455Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Leave the J 34741-3  in place until the reverse clutch and housing assembly is ready to be installed. See Special Tools .
  2. Install the J 34741-3  over the input shaft oil seal rings. See Special Tools . Use a twisting motion to install the J 34741-3  . See Special Tools . The J 34741-3  must contact the third clutch housing hub. See Special Tools .
scientia non olet · About LEMON Manuals