LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Forward and Coast Clutch Installation >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

J 39053  Forward and Coast Clutch Assembly Installer. See Special Tools .

    Fig 1: Installing The Forward And Coast Clutch And Support Assembly (636-834) Into The Barrel Of The Case
    GM11925Courtesy of GENERAL MOTORS CORP.
    CAUTION: The forward and coast clutch assembly weighs approximately 50 lbs. Personal injury may result if you drop the assembly.
  1. Install the J 39053  into the forward and coast clutch and support assembly (636-834). See Special Tools .
  2. Using a chain hoist or suitable lifting equipment, install the forward and coast clutch and support assembly (636-834) into the barrel of the case. The two bolt holes and feed holes must line up with the holes in the bottom of the case.
scientia non olet · About LEMON Manuals