LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Final Drive Internal Gear and Snap Ring Installation

Final Drive Internal Gear and Snap Ring Installation

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Final Drive Internal Gear With Groove Aligned Up
    GM11846Courtesy of GENERAL MOTORS CORP.
  1. Install the final drive internal gear (120) with the groove up.
  2. Install the final drive internal gear snap ring (135) flat side down.
    3. Fig 2: Setting Final Drive Internal Gear Snap Ring With A Punch
    GM11926Courtesy of GENERAL MOTORS CORP.
  3. The final drive internal gear snap ring (135) opening should be in the actuator rod area. Set the final drive internal gear snap ring (135) in place with a light tap on a punch.
scientia non olet · About LEMON Manuals