LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Final Drive Carrier/Differential Carrier Install

Final Drive Carrier/Differential Carrier Install

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Drive Carrier & Differential Carrier
    GM15506Courtesy of GENERAL MOTORS CORP.
  1. Install the sun gear (121) with the bushing side facing the differential (110).
  2. Install the final drive carrier (100) with the thrust bearing (102) secured on the sun gear side. Turn the unit until the unit meshes with the sun gear and the internal gear teeth.
  3. Install the left thrust washer (117). Install the left differential side gear (118).
    4. Fig 2: Identifying Differential Housing Retaining Bolts
    GM762303Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Place the transmission in Park using the manual shaft. Attach the differential housing (110) and four bolts (119). Locate dowels on the final drive carrier Insert these dowels into holes in the differential carrier for proper assembly.

    Tighten:  Tighten the bolts using a star pattern to 70-76 N.m (52-56 lb ft).

scientia non olet · About LEMON Manuals