LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Differential Carrier Overhaul

Differential Carrier Overhaul

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Differential Carrier Components
    GM15503Courtesy of GENERAL MOTORS CORP.
  1. Use a pin punch to drive out the differential pinion shaft retaining pin (115). Remove the following parts:
    • The differential pinion shaft (114)
    • The two pinion gears (116)
    • The two pinion thrust washers (113)
  2. Remove the right differential side gear and output shaft (112). Remove the differential thrust washer (111).
  3. Inspect the gears and the thrust washers for burrs or damage.
  4. Install the following parts:
    • The differential thrust washer (111)
    • The right differential side gear and output shaft (112)
    • The output shaft snap ring (56)
    • The two pinion thrust washers (113)

      The two pinion gears (116)

  5. Install the differential pinion shaft (114).
  6. Install the differential pinion shaft retaining pin (115).
scientia non olet · About LEMON Manuals