Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Outer Tie Rod Assembly To Inner Tie Rod Assembly

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod (3) to the inner tie rod (1).
Do not tighten the jam nut (2).

Fig 2: View Of Outer Tie Rod & Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Install the outer tie rod (2) to the steering knuckle (1).

Fig 3: Identifying Outer Tie Rod & Retaining Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .

Install the outer tie rod retaining nut (2).
Tighten:
- Tighten the outer tie rod retaining nut (2) to 47 N.m (35 lb ft).
- Tighten the outer tie rod retaining nut (2) up to 1/6 additional turn, or 70 N.m (52 lb ft) maximum.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.

IMPORTANT: Ensure that the rack and pinion boot is not twisted or puckered during toe adjustment.

Adjust the front toe. Refer to Front Toe Adjustment .