LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Power Steering System) >> Repair Instructions >> Rack and Pinion Boot Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement .
    4. Fig 1: Identifying Inner Tie Rod Assembly Jam Nut
    GM297360Courtesy of GENERAL MOTORS CORP.
  4. Remove the hex jam nut (2) from the inner tie rod.
    5. Fig 2: Removing/Installing Tie Rod End Clamp At Rack & Pinion Boot
    GM297362Courtesy of GENERAL MOTORS CORP.
  5. Remove the tie rod end clamp (2) from the rack and pinion boot (1).
  6. Remove the rack and pinion boot clamp from the rack and pinion boot.
    7. Fig 3: Removing Rack & Pinion Boot
    GM297368Courtesy of GENERAL MOTORS CORP.
  7. Remove the rack and pinion boot (1) from the steering gear.
scientia non olet · About LEMON Manuals