LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Secondary Air Relay Bracket & Retaining Nuts
    GM518257Courtesy of GENERAL MOTORS CORP.
  1. Remove the secondary AIR relay bracket retaining nuts (2).
  2. Remove the secondary AIR relay bracket (1) from the mounting studs.
    3. Fig 2: View Of Secondary Air Relay Bracket, Surge Tank Retaining Nut And Bolt
    GM517960Courtesy of GENERAL MOTORS CORP.
  3. Remove the surge tank retaining nut (2) and bolt (3).
  4. Position and support the surge tank out of the way.
    5. Fig 3: View Of Power Steering Pump Pulley Remover
    GM649303Courtesy of GENERAL MOTORS CORP.
  5. Remove the drive belt. Refer to Drive Belt Replacement .
  6. Using J 25034-C  remove the power steering pump pulley. See Special Tools .
scientia non olet · About LEMON Manuals