LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Rack & Related Components
    GM460600Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pressure hose to the vehicle.
  2. Connect the power steering pressure hose to the bracket at the frame.
    3. NOTE: Refer to Fastener Notice .
  3. Install the power steering pressure hose to the power steering gear.

    Tighten:  Tighten the power steering pressure hose to power steering gear to 27 N.m (20 lb ft).

    4. Fig 2: Lower Engine Mounting Bracket
    GM493550Courtesy of GENERAL MOTORS CORP.
  4. Install the power steering pressure hose bracket and retaining nut to the cylinder head.

    Tighten:  Tighten power steering pressure hose bracket retaining nut (2) to cylinder head to 9 N.m (80 lb in).

  5. Install the wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  6. Install the power steering gear heat shield. Refer to Power Steering Gear Heat Shield Replacement .
  7. Lower the vehicle.
    8. Fig 3: View Of Power Steering Pressure Hose & Power Steering Pump
    GM284268Courtesy of GENERAL MOTORS CORP.
  8. Install the power steering pressure hose to the power steering pump.

    Tighten:  Tighten the power steering pressure hose to power steering pump to 27 N.m (20 lb ft).

  9. Remove the drain pan from under the vehicle.
  10. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals