LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Power Steering System) >> Repair Instructions >> Power Steering Gear Heat Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Steering Rack
    GM293350Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (FE1, FE3) or Stabilizer Shaft Link Replacement (FE7) .
  3. Rotate the stabilizer shaft downward.
  4. Remove the electrical harness clip from the power steering gear heat shield.
  5. Remove power steering gear heat shield mounting bolts.
  6. Remove the power steering gear heat shield.
scientia non olet · About LEMON Manuals